Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 147
    4. : How to disassemble the Alfa Romeo 147 turbine.

Alfa Romeo 147 - Video tutorial

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: Turbine
Operation: How to disassemble the Alfa Romeo 147 turbine.

In today's video, we will see how to disassemble the turbocharger of the Alfa Romeo 147. This operation is necessary in order to refurbish or replace the part, depending on the conditions or needs. We recommend working with the car cold, in order to avoid problems. We position the car on the lift or at least lift the front part. We remove the lower fairing. Subsequently, we remove the front bumper. At this point, we can proceed to locate the turbocharger and proceed with its removal, being careful in the disassembly of the components.


Posted on 23 July 2023 by ScegliAuto



How to remove the front bumper of an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, we will have to open the front hood of our Alfa Romeo 147. So let's start by unscrewing and removing all the screws and all the bolt
Where is the Alfa Romeo 147 fuse box located
Alfa Romeo 147 (2000-2010 / MK 1) If you cannot find the position in which the fuse box of your Alfa Romeo 147 is installed then all you have to do is pay attention to the following m
How to remove the inner pillars on the Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Today we will see how to remove the internal plastic pillars on the Alfa Romeo 147, following these simple and quick steps. First we get on board the

    Frequently Asked Questions

    • 147 2000-2010 - How much does the replacement of the turbine in the Alfa Romeo 147 cost? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos