Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A3
    4. : How to replace the front hub bearing in the Audi A3?

Audi A3 - Video tutorial

Model: Audi A3 MK 2, 8P - Years 2003-2013
Part: Bearing
Operation: How to replace the front hub bearing in the Audi A3?

In this tutorial, we can see how to replace the front wheel bearing in the Audi A3, a simple operation but one that requires good manual dexterity. First of all, we lift the side on which we will be working with a jack, taking the necessary safety measures, then we remove both the wheel and the brake caliper. Next, we remove the rotor, unscrew the two bolts securing the lower arm, and remove the half shaft from the hub. At this point, we can unscrew the last indicated bolts and extract the bearing using a hammer. To install the replacement and reassemble everything, simply follow the reverse procedure.


Posted on 16 October 2023 by ScegliAuto



How to remove the front disc bearing of an Audi A3
Audi A3 (2003-2013 / MK 2, 8P) How to remove the front disc bearing of an Audi A3? First of all, we position our car on a column bridge (jack), loosen the pins with a telescopic wr
How to replace the wheel bearing
Audi A3 (2003-2013 / MK 2, 8P) The following operation must be done by lifting the car and in total safety since a lot of force is required to disassemble the hub. You find that yo
How to change the wheel on an Audi A3
Audi A3 (2012-2019 / 8V, MK 3) Let's see how to change the wheel on an Audi A3: we open the trunk and take the wheel removal kit which includes: jack, jack lever, screwdriver, bolt

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos