Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A4
    4. : How to replace the crankshaft position sensor in the Audi A4?

Audi A4 - Video tutorial

Model: Audi A4 B7 - Years 2004-2008
Part: Crankshaft RPM sensor
Operation: How to replace the crankshaft position sensor in the Audi A4?

In this tutorial, we can see how to replace the crankshaft position sensor in the Audi A4, a very simple operation. Before proceeding, make sure the engine is completely cold to work safely. As shown, the sensor in question is located about halfway up the left wall of the engine. To access it, we will need to remove the battery and its support first. It is also held in place by a single bolt, which can be unscrewed with a 10mm socket wrench. Once removed, we can disconnect the connector, insert the replacement, and follow the reverse procedure.


Posted on 9 December 2023 by ScegliAuto



How to replace the crankshaft rpm sensor on Audi A4
Audi A4 (2000-2004 / B6) Let's see how to replace the crankshaft rpm sensor on Audi A4: we raise the front engine hood, we secure the same with the holding rod. We locate the
How to replace the engine speed sensor of the Audi A4 b6 1.8T
Audi A4 (2000-2004 / B6) The guide shows how to replace the engine speed sensor of the Audi A4 b6 with 1.8T engine. The first operation to carry out is to remove the coolant
Replacement of the crankshaft oil seal of the Audi A4 2.0 TDI.
Audi A4 (2007-2016 / B8) In this guide, we will see the necessary procedure for disassembling and replacing the crankshaft oil seal of the Audi A4 2.0 TDI. In order to access

    Frequently Asked Questions

    • A4 2007-2016 - Why does the speed sensor of the Audi A4 fail? Read Answer
    • A4 2000-2004 - How much does the engine speed sensor cost on an Audi A4? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos