Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Audi
  4. :
  5. A4
  6. : How do you replace the control unit of the Audi A4?

Audi A4 - Video tutorial

Model: Audi A4 B7 - Years 2004-2008
Part: Control unit
Operation: How do you replace the control unit of the Audi A4?

The control unit of the Audi A4 is located inside the engine compartment: it is located in the upper part of it, immediately below the windshield on the driver's side. To reach it, you can open the hood and then loosen the appropriate protective panel. By doing so, the control unit can be freed from the appropriate fixing screws and disconnected from its power cables: at this point it will be possible to connect the new control unit to them and it will need to be fixed in its seat, covering everything with the panel and checking that everything is functioning.


Posted on 8 May 2024 by ScegliAuto



How to remove the control unit on Audi A4
Audi A4 (1994-2000 / B5) How to disassemble the control unit on Audi A4? Let's see in this video how to perform the disassembly: unscrew the wiper rods with a special key, re
Audi A4 B6-B7 airbag control unit removal instructions
Audi A4 (2004-2008 / B7) In this video tutorial we will see the main instructions to be able to access and remove the airbag control unit of an Audi A4 B6-B7. First we go to
Removing the parking sensor control unit Audi A4 B6 - B7
Audi A4 (2004-2008 / B7) In this video tutorial we will see how to remove, in simple steps, the parking sensor control unit of an Audi A4 B6-B7. First of all we are going to

Other guides that may interest you

    Frequently Asked Questions

    • A4 2014-2023 - Where is the Audi A4 engine control unit located? Read Answer
    • A4 2004-2008 - Where is the ECU of the 2005 Audi A4? Read Answer
    • A4 2007-2016 - Where is the handbrake control unit of an Audi A4 located? Read Answer
    • A4 2007-2016 - Where is the ECU of an Audi A4 located? Read Answer
    • A4 2007-2016 - Where is the Audi A4 central locking control unit located? Read Answer
    • A4 2014-2023 - Yellow warning light with triangle and exclamation mark on Audi A4? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos