Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Benelli 502c - Videoguide

Benelli 502c
How to perform the routine maintenance service on the Benelli 502C
In this short and simple guide, we will see how to perform the routine maintenance on the Benelli 502C motorcycle. First, put the motorcycle on a stand and …read all…
Posted on 3 April 2024 by ScegliAuto
Benelli 502c
How to disassemble the seat of the Benelli 502C.
The seat of the Benelli 502c motorcycle is perhaps the easiest to remove. As we can see from the video, there are no screws or other special fasteners holding …read all…
Posted on 22 May 2023 by ScegliAuto
Benelli 502c
How to set the time on the Benelli 502C
In this guide, let's see how to change and adjust the time of the Benelli 502C motorcycle, in simple and quick steps. First we put our bike on the stand and …read all…
Posted on 21 December 2022 by ScegliAuto
Benelli 502c
How do you change the Benelli 502C engine oil?
In order to replace the Benelli 502C engine oil, you need to unscrew the oil drain plug which is positioned in the lower left part of the bike. Once this cap …read all…
Posted on 17 May 2024 by ScegliAuto
Benelli 502c
How to set the time of a Benelli 502C
Before we can start, we will have to go and sit on the saddle of our Benelli 502C. So let's start by activating the instrument panel and the related on-board …read all…
Posted on 3 February 2024 by ScegliAuto
-board computer (1) Checks and maintenance (2) Engine oil (1) (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos