Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Beta Rr 200 - Videoguide

Beta Rr 200
How do you replace the oil pump of the Beta RR 200?
In order to remove the oil pump of the Beta RR 200, you need to remove the side panels located at the front of the motorcycle, immediately below the fuel tank. …read all…
Posted on 14 May 2024 by ScegliAuto
Beta Rr 200
How do you replace the clutch of the Beta RR 200?
The replacement of the clutch on the Beta RR 200 is done by loosening the screws that secure the cover of the crankcase, located in the lower center of the …read all…
Posted on 9 November 2023 by ScegliAuto
Beta Rr 200
How do you replace the instrument panel battery of the Beta RR 200?
In order to replace the instrument panel battery on the Beta RR 200, you need to loosen the screws that secure the instrument panel to its housing: these …read all…
Posted on 18 September 2023 by ScegliAuto
Beta Rr 200
How to turn off the engine light on the Beta RR 200
In this short and simple guide, let's see how to reset the failure or service warning light of the engine of the Beta RR 200 enduro bike, but also of the RR …read all…
Posted on 7 May 2023 by ScegliAuto
Beta Rr 200
Change the engine oil on Beta RR 200
Let's see in this video how to carry out the routine maintenance coupon, by changing the oil, on a Beta RR 200 motorcycle. First of all, let's remove the …read all…
Posted on 6 February 2024 by ScegliAuto
Beta Rr 200
Beta RR 200 engine oil replacement
Today we will see how to replace the engine oil of a 2020 Beta RR 200. First of all, let's unscrew the oil vent bolt with a socket wrench, which we find under …read all…
Posted on 24 December 2023 by ScegliAuto
Checks and maintenance (1) Clutch (1) Engine oil (2) Pump (1) Instrument cluster (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos