Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 5
    4. : How to replace the accelerator pedal of the BMW 5 Series.

BMW Serie 5 - Video tutorial

Model: BMW Serie 5 E61, E60 - Years 2003-2010
Part: Accelerator
Operation: How to replace the accelerator pedal of the BMW 5 Series.

Today's guide will show us how to disassemble and replace the accelerator pedal of the BMW 5 Series, following these simple and quick steps. First, we get into the car on the driver's side and begin unscrewing the fastening screws of the accelerator pedal. Then, we disconnect the electrical connector of the accelerator pedal position sensor located on the back of it, as shown in the video. At this point, we remove and replace the accelerator pedal with the new or original one, and then apply the reverse process for reassembly!


Posted on 28 May 2023 by ScegliAuto



How to reset the automatic transmission of a BMW 5 Series E60.
BMW Serie 5 (2003-2010 / E61, E60) In this video we will see how to reset the automatic transmission of a BMW E60. First we are going to place the key in position 1-2. Then we turn fur
How to reset the Bmw Serie 5 ECU
BMW Serie 5 (1995-2003 / E39) In this guide, let's see the main instructions that will allow us to reset the BMW 5 Series engine control unit. First of all, we get on board the ca
How to reset the automatic gearbox failure warning on the BMW 5 Series E60
BMW Serie 5 (2003-2010 / E61, E60) In this video tutorial we will see the steps that will allow us to reset the automatic gearshift warning light on the BMW 5 Series E60, but also on t

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos