Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 7
    4. : How to remove the rear door handle in the BMW 7 Series?

BMW Serie 7 - Video tutorial

Model: BMW Serie 7 G70 - Years 2022-2024
Part: Handle
Operation: How to remove the rear door handle in the BMW 7 Series?

In this tutorial we can see how to disassemble the rear door handle in the BMW 7 Series, a very simple and quick operation. First of all, we open the door we will be working on, then we lift the cover on the inner edge of the door, locate the small plastic cap and remove it. We then unscrew the bolt accessible from the hole using a Torx T15 key, grab the handle and separate it from the door by pulling it outwards. At this point, all that remains is to disconnect the connector and install the replacement following the reverse procedure.


Posted on 13 May 2024 by ScegliAuto



How to replace the door panel handle on BMW 7 series
BMW Serie 7 (2001-2008 / MK 4, E68, E65, E67, E66) How to remove and replace the door handle on a BMW 7 Series? We remove the plastic placed under the handle with a lever, then unscrew the tightening
Rear door handle removal instructions
BMW Serie 7 (2001-2008 / MK 4, E68, E65, E67, E66) If the external rear door handle has to be removed, it is clear from the outset that it is not necessary to remove the door panel (in the video the p
How to replace the fuel pump in the BMW 7 Series?
BMW Serie 7 (2008-2015 / F02, F01, MK 5) In this tutorial, we can see how to replace the fuel pump in the BMW 7 Series, a very simple and fast operation. Before proceeding, disconnect the ne

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos