Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Equinox
    4. : How to know the fuse diagram of a Chevrolet Equinox

Chevrolet Equinox - Video tutorial

Model: Chevrolet Equinox MK 2 - Years 2010-2017
Part: Fuse box
Operation: How to know the fuse diagram of a Chevrolet Equinox

In this video tutorial, we are shown the fuse diagrams related to a Chevrolet Equinox car. In relation to the box located inside the engine compartment, it has fuses assigned to: ventilation system, ignition coil, fuel pump, ABS module, battery control module, instrument panel, panoramic roof, solenoid pump, front and rear wipers, air conditioning compressor, horn, high beams, low beams, fog lights, etc. The box located inside the passenger compartment instead has fuses related to: radio, heating system, air conditioning, parking assist, front camera, data link connector, battery control sensor, audio amplifier, etc.


Posted on 16 May 2024 by ScegliAuto



Where are the Chevrolet Equinox fuses located?
Chevrolet Equinox (2010-2017 / MK 2) The Chevrolet Equinox fuses are located inside the special fuse boxes that are present inside the vehicle. In this model of car there are two: one is
To locate the fuse boxes and know their diagrams in a Chevrolet Equinox.
Chevrolet Equinox (2005-2009 / MK 1) Locating the fuse box of a Chevrolet Equinox is quite simple. The first box can be found in the vehicle's cabin, exactly on the passenger side, behin
Chevrolet Equinox battery replacement
Chevrolet Equinox (2010-2017 / MK 2) Let's find out in this guide how to disassemble and replace the Chevrolet Equinox battery, following the instructions below. First we open the engine

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos