Do it yourself
| ||||
|
Citroen C3 - Video tutorial
Model: Citroen C3
SC
- Years 2009-2016 The youtuber does not just show us how to replace the accelerator pedal, but also provides us with all the data that led him to understand the type of failure. And it makes us understand the importance of owning an OBD II reader Meanwhile, at the end of the stroke, the accelerator pedal gave an annoying click at the end of the stroke, then with the OBD II reader and with the use of a telephone app (ODBclick ) analyzed the stored error codes. The offending error was P2137, acceleration / pedal sensor voltage correlation code. The cost of the replacement is around 107.00 / 110.00 euros on the major e-commerce platforms. After removing the fuse cover panel, unscrew the 3 10MM nuts that secure the accelerator pedal; once the pedal has been removed, remove the stand from the fixing on the engine side wall, in order to disconnect the connector. We proceed in the reverse order for assembly.
Posted on 14 October 2022 by ScegliAuto
How to replace the heating resistor of the Citroen C3
Citroen C3 (2009-2016 / SC) To replace the heating resistor of the Citroen C3, we remove the plastic under the steering wheel simply by pulling it to release the plastic clips;
Citroen C3 brake oil replacement
Citroen C3 (2002-2009 / FN, FC) Let's see in this video how to replace the brake oil of a Citroen C3 first series, or just topping up the fluid. First of all we open and lift the en
How to open the hood on the Citroen C3
Citroen C3 (2002-2009 / FN, FC) In this video tutorial you can see how the engine hood of a Citroen C3 opens and closes, following some simple practical steps: first you need to sec Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.038
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |