Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. Ds3
    4. : How to change the diesel fuel filter on the Citroen DS3 HDi

Citroen Ds3 - Video tutorial

Model: Citroen Ds3 MK 1 - Years 2010-2019
Part: Diesel filter
Operation: How to change the diesel fuel filter on the Citroen DS3 HDi

In this video we can see how to change the diesel filter on a Citroen DS 3: we access the filter from underneath the car, so we will need to lift it to have easier access. As we can see, the filter is located in the rear right, under the tank; we will need to remove the protection with a screwdriver, so we can see the rear part of the filter. In the center of the cap there is a 19 screw that we need to unscrew to remove it. This way we can remove the cap with the filter inside that we need to change. We put the new filter back in the cleaned cap and then we will be good for another 60,000 km. Be careful to reattach all the electrical connections that we had removed earlier, and the job is done.


Posted on 22 April 2024 by ScegliAuto



Replacing the diesel filter on the Citroen DS3 1.6 HDI
Citroen Ds3 (2010-2019 / MK 1) In this video tutorial we will see how to remove and replace the diesel filter on Citroen DS3 1.6 HDI, following these simple steps. First of all we
How to top up the wax fluid on the Citroen DS3 1.6 HDI
Citroen Ds3 (2010-2019 / MK 1) In this video tutorial we will see the instructions that will allow us to top up the wax fluid for the particulate filter on the Citroen DS3 1.6 HDI,
Where is the fuel filter located in the Citroen DS3 and how can it be replaced?
Citroen Ds3 (2010-2019 / MK 1) In this video, we can see where the fuel filter is located in the Citroen DS3 and how to replace it, a very simple and inexpensive operation. As show

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos