Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Enfield
    3. :
  3. Classic 500
    4. : How to replace the rear suspensions of the Royal Enfield Classic 500

Model: Enfield Classic 500
Part: Suspensions
How to replace the rear suspensions of the Royal Enfield Classic 500

Below we will see the instructions that will allow us to disassemble and replace the rear suspensions of the Royal Enfield Classic 500 motorcycle. First of all, we put our motorcycle on the central stand and start unscrewing the upper and lower bolt of the suspension, in order to disconnect it and remove it; remember that the motorcycle is equipped with two suspensions, one on the right side and one on the left side. Once removed, it will be possible to install new ones, with the same characteristics; finally, we will adjust the suspensions (if available).


Posted on 15 April 2024 by ScegliAuto



How to disassemble the spark plug of a Royal Enfield Classic 500
Classic 500 Before we begin, we will need to place our Royal Enfield Classic 500 in an upright position. So let's start by disconnecting the plug of the spark pl
Battery replacement on Royal Enfield 500 Classic
Classic 500 In today's video we will see the instructions that will allow us to disassemble and replace the engine battery on a Royal Enfield Classic 500. First
How to replace the battery on the Royal Enfield Classic 500
Classic 500 Let's find out the main steps that will allow us to disassemble and replace the battery on the Royal Enfield Classic 500, following the instructions

How do you replace the piston on the Sherco SE 250?

The Sherco SE 250 piston is replaced by loosening the screws that secure the cylinder in the upper part of the engine block: in order to remove this cylinder it will also be necessary to disconnect the connectors connected to the engine block itself. Once the cylinder has been removed, it will be possible to access the underlying piston, which will have to be detached from the relative connecting rod by removing the relative fixing ring. When this in turn has been removed, it will be possible to insert the new spare part, then also installing the cylinder.

Watch the video!


by ScegliAuto

More videos