Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Ducato
    4. : Fiat Ducato reverse switch replacement

Fiat Ducato - Video tutorial

Model: Fiat Ducato - Years 2002-2006
Part: Reverse gear switch
Operation: Fiat Ducato reverse switch replacement

Open the hood and start by unscrewing the round cover of the filter box, unscrewing the side fixing screws. Remove the filter itself and with a 10 wrench, unscrew the fixing bolts located inside the filter box, in its rear area. Break the metal clamps of the upper air duct with a suitable cutting pliers and remove the tube from the filter box. Then go to the lower duct where, to remove the clamp, you need to unscrew the screw below. Finally, you can access the famous switch! Disconnect the connector, unscrew it and fit the new one.


Posted on 5 January 2024 by ScegliAuto



How to change the reverse light switch in a Fiat Ducato camper
Fiat Ducato (2002-2006 / ) This video tutorial explains how to change the reverse light switch in a Fiat Ducato camper in case it should break down. Sometimes, in fact, it may
How to change the reverse light switch on Fiat Ducato (2006)
Fiat Ducato (2002-2006 / ) In this video tutorial we will see how to remove and replace the reverse gear switch on the second series 2006 Fiat Ducato with 2.8 JTD engine. First
How do you replace the reverse gear switch on a Fiat Ducato?
Fiat Ducato (1993-2016 / MK 2) In order to replace the reverse gear switch on the Fiat Ducato, you need to open the bonnet so that you can access the components inside the engine c

    Frequently Asked Questions

    • Ducato 2006-2014 - Where is the reverse switch of the Fiat Ducato located? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos