Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to test and clean the EGR valve of the Fiat Panda 1.3 Multijet

Fiat Panda - Video tutorial

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: EGR valve
Operation: How to test and clean the EGR valve of the Fiat Panda 1.3 Multijet

Today in this guide, we will see the instructions that will allow us to test and clean the EGR valve of the Fiat Panda 1.3 Multijet. First, we open the hood and start disassembling and removing the plastic cover and the air intake hose, loosening the metal clamp screw; then we start the engine and check the exhaust gas measurement through the appropriate tool, as shown in the video. If the gas values are not within the normal range, it is very likely that the EGR valve is very dirty; we then spray a specific cleaning product, disassembling the valve if necessary.


Posted on 8 May 2024 by ScegliAuto



How to remove the EGR valve on the Fiat Panda 169 1.3 Multijet?
Fiat Panda (2003-2012 / 169, MK 2) In today's video tutorial we will see how to remove the EGR valve on the Fiat Panda 169, with 1.3 MultiJet engine. First of all we open the bonnet of
How do you replace the EGR valve on the Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) In order to replace the EGR valve on the Fiat Panda, you need to open the bonnet, so that you can access the components located inside the engine com
Disassembly and cleaning of the EGR valve
Fiat Panda (2003-2012 / 169, MK 2) The EGR valve is used to pass part of the exhaust gases back to the intake in order to reduce emissions: for this reason, over time, it tends to clog

    Frequently Asked Questions

    • Panda 2012-2021 - How much does it cost to replace the EGR valve in the Fiat Panda? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos