Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Ducato
    4. : How to replace the water pump of the Fiat Ducato 2.8 JTD

Fiat Ducato - Video tutorial

Model: Fiat Ducato MK 2 - Years 1993-2016
Part: Pump
Operation: How to replace the water pump of the Fiat Ducato 2.8 JTD

Today's main steps will show us how to disassemble and replace the coolant pump of the Fiat Ducato 2.8 JTD. First, we lift the vehicle and start by disassembling and removing the right front wheel; then we remove the wheel arch and disconnect the serpentine belt, subsequently removing the crankshaft pulley, as shown in the video. At this point, we remove the timing belt and disconnect the water pump hose, unscrewing the fixing screws to remove it and replace it with the new one, following the video tutorial until the end!


Posted on 15 May 2024 by ScegliAuto



How do you replace the timing belt on the Fiat Ducato 2.8 JTD?
Fiat Ducato (2002-2006 / ) In order to replace the timing belt of the Fiat Ducato 2.8 JTD, the vehicle must be lifted so that the front right wheel and the relative wheel arch
Fiat Ducato 2.8 JTD gearbox oil replacement
Fiat Ducato (2002-2006 / ) Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all
How to clean the water filter of a Fiat Ducato Rimor
Fiat Ducato (2002-2006 / ) Before we can begin, we will have to enter the living area of our Fiat Ducato Rimor, and then remove the seat bench from the main table, simply by li

    Frequently Asked Questions

    • Ducato 2014-2023 - How to change the windshield wiper pump in the Fiat Ducato? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos