Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Captiva
    4. : Where is the fuse box of the Holden Captiva located?

Chevrolet Captiva - Video tutorial

Model: Chevrolet Captiva CG - Years 2006-2018
Part: Fuse box
Operation: Where is the fuse box of the Holden Captiva located?

If you don't know where the box containing all the various fuses of your Holden Captiva is located, don't worry because you just need to carefully read the following guide and follow the steps described to locate it in a few seconds and without any danger. First of all, reach the driver's seat and make sure your Holden Captiva is turned off. Then, shift your attention to the lower part of the dashboard and locate the protective panel located on the side. Finally, remove the panel in question and then locate the fuses you were looking for.


Posted on 13 December 2023 by ScegliAuto



How to know the fuse diagram of a 2008 Holden Captiva.
Chevrolet Captiva (2006-2016 / CG) The 2008 Holden Captiva car has two fuse boxes, one located inside the vehicle cabin and the other located in the engine compartment. The first fuse
How do I replace the air filter on the Holden Captiva?
Chevrolet Captiva (2006-2016 / CG) In order to replace the air filter of the Holden Captiva you have to open the hood, so that you have access to the filter box located in the left are
How do you replace the cabin filter on the Holden Captiva?
Chevrolet Captiva (2006-2018 / CG) In order to replace the cabin filter of the Holden Captiva, you need to open the glove box located on the front passenger side: in this way you can d

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos