Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Honda
    3. : Crf 450

Honda Crf 450 - Videoguide

Honda Crf 450
How to replace the rear brake pads of the Honda CRF 450?
In order to replace the Honda CRF 450 rear brake pads it is not necessary to completely disassemble the brake caliper by removing it from the disc. It will be …read all…
Posted on 11 September 2022 by ScegliAuto
Honda Crf 450
How to replace the clutch on the Honda CRF 450R?
The replacement of the Honda CRF 450 clutch is carried out by loosening the bolts that secure the crankcase positioned on the right side of the bike, so that …read all…
Posted on 18 May 2024 by ScegliAuto
Honda Crf 450
How to replace the muffler of the Honda CRF 450?
In order to replace the muffler of the Honda CRF 450 it is necessary to loosen the screws that fix the side panel at the rear of the bike. Once this side panel …read all…
Posted on 5 May 2024 by ScegliAuto
Honda Crf 450
How to replace the clutch on the Honda CRF 450R?
In order to replace the Honda CRF 450R clutch, you need to loosen the bolts that secure the circular casing located on the right side of the bike. Once these …read all…
Posted on 28 April 2024 by ScegliAuto
Honda Crf 450
How to remove the radiator on Honda CRF 450R
We see in this video the instructions that will allow us to disassemble the cooling radiator on a Honda CRF 450R enduro motorcycle. First, let's start by …read all…
Posted on 9 February 2024 by ScegliAuto
Honda Crf 450
Oil change and engine filter on Honda CRF 450
The recommended oil, especially if it is close to winter, is 10W40 7100. Warm up the engine, turning it on for a few minutes, in order to make the oil less …read all…
Posted on 28 December 2023 by ScegliAuto
Clutch (2) Muffler (1) Engine oil (1) Brake pads (1) Radiator (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos