Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Husaberg Fe 390 - Videoguide

Husaberg Fe 390
How do you replace the fuel pump of the Husaberg FE 390?
The procedure for replacing the fuel pump on the Husaberg FE 390 involves loosening the screws that secure the seat to its housing and the screws located in …read all…
Posted on 12 September 2023 by ScegliAuto
Husaberg Fe 390
How do you replace the engine of the Husaberg FE 400?
In order to replace the Husaberg FE 400 engine, first of all you need to remove the fairings located on the side of the bike. In order to disassemble the …read all…
Posted on 18 October 2022 by ScegliAuto
Husaberg Fe 390
How do I adjust the valves on the Husaberg FE 390?
In order to adjust the valves of the Husaberg FE 390 you have to unscrew the bolts that fix the saddle to its housing, so that it can be removed. After its …read all…
Posted on 11 August 2022 by ScegliAuto
Husaberg Fe 390
How do I change the oil on Husaberg FE 390?
In order to change the oil of the Husaberg FE390, the protection plate under the engine must be removed by removing the appropriate bolt. Then you will have to …read all…
Posted on 19 February 2024 by ScegliAuto
Husaberg Fe 390
Husaberg FE 390 piston disassembly instructions
In this video tutorial we will see how to disassemble the piston of a Husaberg FE 390, but also on other motorcycle models such as KTM and Husqvarna, following …read all…
Posted on 2 January 2024 by ScegliAuto
Husaberg Fe 390
Oil change and engine filter on Husaberg FE 390
Remove the engine guard, remove the upper filler cap and then the lower drain plug (clean the latter as it will have residues). Collect the used oil in a pan. …read all…
Posted on 23 December 2023 by ScegliAuto
Engine (1) Engine oil (2) Fuel pump (1) Valve (1)

See also:

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos