Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Santa Fe
    4. : Replacement of the crankshaft sensor of the Hyundai Santa Fe 2.4L.

Hyundai Santa Fe - Video tutorial

Model: Hyundai Santa Fe MK 1 - Years 2000-2006
Part: Crankshaft RPM sensor
Operation: Replacement of the crankshaft sensor of the Hyundai Santa Fe 2.4L.

Today's guide will illustrate the necessary steps to disassemble and replace the crankshaft position sensor of the Hyundai Santa Fe 2.4L. First, we open the hood and proceed to disconnect the battery. Then, we lift the vehicle and remove the right front wheel, subsequently removing the fender liner. At this point, we remove the crankshaft pulley and, consequently, the serpentine belt. Next, we unscrew the screws of the crankshaft sensor and disconnect the electrical connector to remove it and replace it with the new original one, following the video tutorial until the end!


Posted on 30 January 2024 by ScegliAuto



Where is the crankshaft position sensor located in the Hyundai Santa Fe?
Hyundai Santa Fe (2012-2018 / MK 3) In this video, we can see where the crankshaft position sensor is located in the Hyundai Santa Fe, which is useful in case we need to replace it. As
Where is the engine speed sensor located in the Hyundai Santa Fe and how to replace it?
Hyundai Santa Fe (2012-2018 / MK 3) In this video, we can see where the crankshaft position sensor is located in the Hyundai Santa Fe, and how to proceed in case we need to replace it.
Replace the timing belt of the Hyundai Santa Fe
Hyundai Santa Fe (2000-2006 / MK 1) Changing the belt is a delicate job, it should be done with a minimum of experience. Anyway, here are the tips to replace the distribution of the Hyu

    Frequently Asked Questions

    • Santa Fe 2000-2006 - Where is the crankshaft sensor of the Hyundai Santafe 2.4? Read Answer
    • Santa Fe 2000-2006 - Where is Hyundai Santafe's camshaft position sensor located? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos