Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. : Cj : How to replace the starter motor of the Jeep CJ

Jeep Cj - Video tutorial

Model: Jeep Cj MK 7, CJ7 - Years 1976-1986
Part: Starter motor
Operation: How to replace the starter motor of the Jeep CJ

The guide shows how to replace the starter motor of CJ (Civilian Jeep) Jeeps. Often these models have problems with starter operation. The first operation to perform is to disconnect the negative pole of the battery to isolate the circuit. On the left side of the engine, under the battery, you can see the starter motor; it is held in place by two bolts which must be unscrewed after disconnecting the control cable. This operation must be performed from the bottom of the vehicle, after having secured it. The replacement with the new piece is very simple: it will be enough, in fact, to realign the new piece with the relevant hole in the flywheel housing and reinstall it in the same position as the previous one. Retighten the two bolts and the control cable. Reconnect the battery and try to start the engine. The replacement is now complete.


Posted on 14 February 2024 by ScegliAuto



Jeep Wrangler Starter Motor Replacement
Jeep Wrangler (1997-2007 / MK 2, TJ) In today's video we will see the steps on how to disassemble and replace the starter motor of the Jeep Wrangler, following the instructions below. Fi
How do you replace the starter motor?
Jeep Cherokee (2013-2023 / MK 5, KL) In this video we learn the procedure that allows us to replace a starter motor. The car used as an example is a Jeep Cherokee, but the replacement wo
How do I replace the starter motor on the Jeep Wrangler?
Jeep Wrangler (1997-2007 / MK 2, TJ) The replacement of the starter motor of the Jeep Wrangler is carried out by opening the hood, so that you can have access to the components inside th

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos