Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Compass
    4. : How to replace the rear windshield wiper of the Jeep Compass

Jeep Compass - Video tutorial

Model: Jeep Compass 552, MK 2 - Years 2016-2024
Part: Windscreen wipers
Operation: How to replace the rear windshield wiper of the Jeep Compass

The following steps will show us how to disassemble and replace the rear windshield wiper or rear wiper blade of the Jeep Compass. First, let's move to the back of the car and start by lifting the windshield wiper arm, also lifting the plastic clip found on the right side; now let's rotate the wiper blade until it detaches and remove it from the arm, as shown in the video. At this point, install the new rear wiper blade, of the correct type and the same size, securely fixing it to the arm and finally securing the plastic clip!


Posted on 25 March 2024 by ScegliAuto



A windshield wiper that interferes with the turn signals on a Jeep Compass.
Jeep Compass (2006-2016 / MK 49, MK 1) In this video we see how on this Jeep Compass there is a strange problem: almost every time the turn signals are activated, the windshield wipers als
How do i replace the battery of the Jeep Compass?
Jeep Compass (2016-2024 / 552, MK 2) Jeep Compass battery replacement is possible by opening the hood to access the engine compartment and locating the battery, which is located immediat
Where are the fuses of the Jeep Compass located?
Jeep Compass (2006-2016 / MK 49, MK 1) All the fuses of the Jeep Compass are contained inside the special fuse box inside the car: the latter is positioned in the engine compartment, in th

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos