Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Grand Cherokee
    4. : How to replace the rear headlight bulbs in the Jeep Grand Cherokee?

Jeep Grand Cherokee - Video tutorial

Model: Jeep Grand Cherokee WK2, MK 4 - Years 2010-2021
Part: Rear light bulb
Operation: How to replace the rear headlight bulbs in the Jeep Grand Cherokee?

In this tutorial, we can see how to replace the tail light bulbs in the Jeep Grand Cherokee, a very simple and quick operation. First of all, make sure the key is not inserted, then open the trunk door, locate the two plastic rivets on the inner edge of the light in question and remove them using a screwdriver with a flat tip. Then, grab the light, pull it towards you and separate it from the body. At this point, we can disconnect the connector, remove the old bulb, insert the replacement and reassemble everything.


Posted on 19 May 2024 by ScegliAuto



How to replace the rear light bulb on the Jeep Grand Cherokee?
Jeep Grand Cherokee (1992-1998 / ZJ, MK 1, ZG) In order to replace the rear light bulb of the Jeep Grand Cherokee you need to open the tailgate, so that the underlying screws fastening the rear li
Disassembly of the headlight of the Jeep Grand Cherokee 2
Jeep Grand Cherokee (1998-2004 / MK 2, WJ) Let's see in this video how to remove and replace the front light assembly of the second series Jeep Grand Cherokee, following these simple steps. Fi
How to replace the rear light bulbs in the Jeep Grand Cherokee?
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) Replacing the rear light bulbs in the Jeep Grand Cherokee is a very simple and quick operation, let's see how to proceed in this tutorial. First we o

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos