Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Kawasaki Z 650 - Videoguide

Kawasaki Z 650
How do you replace the exhaust pipe of the Kawasaki Z650?
The replacement of the muffler on the Kawasaki Z650 is done by loosening the screws that attach it to the corresponding supports, located on the right side of …read all…
Posted on 16 October 2023 by ScegliAuto
Kawasaki Z 650
How do you replace the muffler of the Kawasaki Z650?
In order to replace the exhaust pipe of the Kawasaki Z650, you need to loosen the screws that hold it to the corresponding supports, located on the right side …read all…
Posted on 11 August 2023 by ScegliAuto
Kawasaki Z 650
Where are the fuses on the Kawasaki Z 650 located?
The fuses of the Kawasaki Z 650 are positioned inside the special fuse box installed on the motorbike: to be able to reach it it will be necessary to loosen …read all…
Posted on 29 April 2023 by ScegliAuto
Kawasaki Z 650
How to change the engine oil of Kawasaki Z-650?
In order to replace the Kawasaki Z-650 engine oil, you need to unscrew the oil drain plug located in the lower left part of the bike, so that all the used oil …read all…
Posted on 29 May 2024 by ScegliAuto
Kawasaki Z 650
ECU control unit disassembly on Kawasaki Z 650
In this video tutorial we will see how to disassemble the ECU on a Kawasaki Z 650, following these simple steps. First we are going to disassemble the plastic …read all…
Posted on 21 January 2024 by ScegliAuto
Kawasaki Z 650
How to remove the tank on the Kawasaki Z 650
We see in this video the instructions that will allow us to disassemble the fuel tank on a Kawasaki Z 650. First we are going to remove the screws that we find …read all…
Posted on 13 January 2024 by ScegliAuto
Control unit (1) Muffler (2) Engine oil (1) Fuse box (1) (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos