Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. (Various brands)
    3. :
  3. Various
    4. : How to replace or top up the coolant on a KTM motorcycle

Model: (Various brands) Various
Part: Antifreeze liquid
How to replace or top up the coolant on a KTM motorcycle

The first warning, which might seem trivial - but it's not - is to check the coolant with a cold engine. Let's check if there is the liquid, which is specific for cooling, which is also a lubricant. So don't just use water because the ferrous parts oxidize. Be careful because there are two radiators and therefore when we put the liquid, air often forms in the left radiator. We therefore have to tilt the bike significantly to the left, so that the air can transfer to the other side. Then we top up again. Some models have a bleed screw, just for this service, placed right on the apex of the cup. If the air remained in the radiator, the liquid would have more difficulty turning and would create a foam which would cause damage. However, the liquid must be changed once a year, because it decays over time.


Posted on 21 May 2023 by ScegliAuto



How to top up the coolant liquid.
(Various brands) Various Performing a coolant top-up is a very simple operation that can be done independently. Thanks to this short video tutorial, we will explain the steps
How to replace the coolant in the scooter.
(Various brands) Various In this video tutorial, we can see how to replace the coolant in a scooter. First, we open the cap of the coolant tank; then, we loosen the hose clam
How to top up the coolant on the Honda Sh 150
(Various brands) Various If we want to check and check the fluid levels on our scooter we can follow the instructions that are given in the description below and refer to the

How do you replace the headlight bulb of the Triumph Daytona 675R?

In order to replace the headlight bulb of the Triumph Daytona 675R, you need to loosen the screws that secure the appropriate protective panels inside the bulbs: these will be immediately below the handlebars, on the sides of the front fork. Once these covering panels have been removed, it will be possible to disconnect the connector connected to the bulb, removing it from its housing; at this point, it will be possible to connect the new bulb to the connector, inserting it into the headlight and verifying that everything works correctly.

Watch the video!


by ScegliAuto

More videos