Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Lml
    3. :
  3. Star 125
    4. : How to change the engine oil on a LML Star 125?

Model: Lml Star 125
Part: Engine oil
How to change the engine oil on a LML Star 125?

To change the engine oil on an LML Star 125, start by placing the scooter on a flat surface and lifting it with a center stand to ensure stability. Then remove the oil drain plug and the oil filler cap to allow the old oil to drain completely. Make sure you have a suitable container to collect the used oil. Once all the oil has drained, securely replace the drain plug. Next, fill the engine with new engine oil using the oil filler cap and a funnel to prevent spills. Consult the owner's manual to know the recommended quantity and type of oil for your LML Star 125. After filling the engine with new oil, make sure to check the oil level using the oil level dipstick and adjust if necessary. Finally, start the scooter and let it run for a few minutes to evenly distribute the new oil in the engine. Check the oil level again and make sure it is within the correct range. Once this procedure is completed, you have successfully changed the engine oil of your LML Star 125.


Posted on 22 April 2024 by ScegliAuto



Change the gearbox oil of the Lml Star 125 - Piaggio Vespa PX 125
Star 125 Let's see today, in this short and simple guide, the steps that will allow us to carry out the routine maintenance service, replacing the transmissio
How to replace the Piaggio Vespa PX 125 - LML Star 125 muffler
Star 125 Below we will see the steps necessary to disassemble and replace the muffler of the Piaggio Vespa PX 125 and LML Star 125. First, put the central sta
How do you measure the oil level of the LML Star 125?
Star 125 In order to measure the oil level of the LML Star 125 it is necessary to extract the dipstick located in the lower part of the bike, near the rear wh

How do you replace the swingarm link bearing on the Beta RR 300?

In order to replace the bearing connecting the swingarm of the Beta RR 300 it is necessary to unscrew the nut that fixes the central pin of the rear wheel of the bike, so that the latter can be removed from its housing. Once the wheel has been removed, it will also be possible to unscrew the screws that secure the brake caliper, removing the latter and accessing the connection of the swingarm. Here there will be the relevant bearing, which must be extracted from its housing and replaced with a new spare part; after replacement, all previously removed components can be mounted.

Watch the video!


by ScegliAuto

More videos