Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Malaguti
    3. :
  3. Fifty Top
    4. : How to disassemble the engine block of the Malaguti Fifty Top.

Model: Malaguti Fifty Top
Part: Engine
How to disassemble the engine block of the Malaguti Fifty Top.

Below we will see the steps necessary to remove the entire engine block from the frame of the Malaguti Fifty Top, following the instructions provided below. First, we put the center stand and start removing the plastic fairings; then we disconnect the electrical wiring of the engine ignition and subsequently the transmission and rear brake cables, as shown in the video. At this point, we disconnect the suspension and unscrew the fastening screws of the carburetor duct; then we lower the engine block to remove it permanently from the frame!


Posted on 29 December 2023 by ScegliAuto



Disassembling and cleaning the Malaguti Fifty Top mixer
Fifty Top In order to disassemble and thus be able to use the mixer in the Malaguti Fifty Top, we first of all place the bike itself in a safe, well-immobilize
How do you replace the clutch on the Malaguti Fifty?
Fifty Top In order to replace the clutch of the Malaguti Fifty it is necessary to loosen the bolts that secure the crankcase positioned on the left side of the
How do you disassemble the gearbox of the Malaguti Fifty?
Fifty Top In order to disassemble the gearbox of the Malaguti Fifty it is necessary to loosen the bolts that secure the cover of the corresponding crankcase, p

How to change the light bulb on a Peugeot Kisbee

In this video we can see how to change the front light bulb of the Peugeot Kisbee scooter: first of all, we need to remove the front shield, unscrewing the six torx screws on the edges of the shield that will allow us to remove it easily. In the center we will find the cap where the bulb is inserted; we will have to unscrew the rubber cap slightly and remove it, after removing the electrical connector. Here we replace the bulb with one of those provided and then put the bulb holder back in place (always remember not to touch the bulb of the new bulb with bare hands). put the cap back in place, put the electrical connector back in place and also the six screws that hold the shield in place. Job done.

Watch the video!


by ScegliAuto

More videos