Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe E
    4. : How to replace the Mercedes' swing arm.

Mercedes Classe E - Video tutorial

Model: Mercedes Classe E W124 - Years 1984-1995
Part: Arm
Operation: How to replace the Mercedes' swing arm.

To replace the arm of the Mercedes E-Class, W124, you must first remove the wheel. Slowly loosen the bolts and then lift the car to remove the wheel completely. Using WD-40 spray and a metal brush, clean the bolt and then remove it with the combination wrench no. 22. After removing the lock, as shown in the video tutorial, remove the arm and then clean the housing. Now we can start reassembling all the new pieces. First, mount the arm and lock it, then insert the wheel and tighten the bolts.


Posted on 1 May 2023 by ScegliAuto



Suspension swing arm installation
Mercedes Classe E (1995-2002 / W210) If you have to replace the upper swinging arm of the suspension, you have to try somehow because the fixing nut of the relative arm pin falls inside
How to disassemble the armrest of the Mercedes 124.
Mercedes Classe E (2009-2016 / W212) Replacing the arm of the Mercedes E-Class is not a difficult operation, especially if you are already familiar with cars. Additionally, with the help
Replacement of wipers on Mercedes E-Class 320
Mercedes Classe E (2002-2009 / W211) To disassemble and subsequently replace the front wipers you must first open the catch that holds the blade fixed to the arm. Now lift the same arm,

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos