Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Coolant replacement for Mercedes C-Class

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W204 - Years 2007-2013
Part: Antifreeze liquid
Operation: Coolant replacement for Mercedes C-Class

Over time and kilometers, the coolant of the Mercedes C-Class loses efficiency and must be replaced to ensure the efficiency of the cooling system. We open the hood of the engine compartment and remove the cap of the expansion tank, then go under the car and remove the underbody panel on the driver's side, near the wheel. We locate the bleed valve of the system, place a basin underneath it to collect the old coolant, and with the help of pliers, open the valve to empty the system. Once emptied, we close the valve, reassemble the panels, and refill the system using the coolant specified by Mercedes in the correct quantity.


Posted on 19 March 2024 by ScegliAuto



How to top up the coolant on a Mercedes C-Class.
Mercedes Classe C (2007-2013 / W204) .. To top up the coolant on a Mercedes C-Class by ourselves, we need to open the hood and locate the reservoir, which is located in the front..
How do you top up the coolant of the Mercedes C-Class?
Mercedes Classe C (2007-2013 / W204) .. to perform the coolant refill on the Mercedes C-Class, you need to open the hood so that you can access the components located inside the engine compartment...
How to replace coolant on Mercedes C-Class
Mercedes Classe C (2000-2007 / W203) .. drain and top up the coolant on the Mercedes C-Class. First, we raise the car and begin to remove the plastic bulkhead that we find under the engine,..

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos