Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Vito
    4. : How to replace the front headlight bulb of the Mercedes Vito

Mercedes Vito - Video tutorial

Model: Mercedes Vito MK 3, W447 - Years 2014-2024
Part: Headlight bulb
Operation: How to replace the front headlight bulb of the Mercedes Vito

In this short and simple guide, we will see how to disassemble and replace the low beam bulb of the front headlight of the Mercedes Vito. First of all, let's move to the side and turn the steering wheel to access the inside of the front wheel arch; then remove the plastic cover to access the back of the headlight, disconnecting the electrical connector to remove the bulb, as shown in the video. At this point, install the new low beam bulb of the front headlight, of the correct type and having the same attachment; then reassemble the plastic cover of the front wheel arch.


Posted on 11 May 2024 by ScegliAuto



How to remove the rear light bulb of a Mercedes Vito
Mercedes Vito (2003-2013 / W639, MK 2) Before we can start, we will have to go and open the tailgate of our Mercedes Vito. So let's start by unscrewing and removing the screws that secure
How do you remove the headlight from the Mercedes Vito?
Mercedes Vito (2014-2024 / MK 3, W447) In order to remove the headlight from the Mercedes Vito, you need to go and open the bonnet, so that you can loosen the screws that fix the panel pos
How to replace the high beam on a Mercedes Vito
Mercedes Vito (2003-2013 / W639, MK 2) Make sure the vehicle is turned off and open the hood to access the engine compartment. Locate the headlight and remove the plastic cover behind the

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos