Do it yourself
Frequently asked questions about cars and motorcycles

Moto Guzzi V7 Stone - Videoguide

Moto Guzzi V7 Stone
How do you replace the rear-view mirror of the Moto Guzzi V7 Stone?

In order to replace the rear-view mirror of the Moto Guzzi V7 Stone, it is necessary to lock the nut that fixes the lower part of the mirror support using an …read all…
Posted on 25 September 2022 by ScegliAuto
Moto Guzzi V7 Stone
How to remove the seat on the Moto Guzzi V7 III Stone (2017)

In this short video we will see how to remove and replace the driver and passenger seats on the 2017 Moto Guzzi V7 III Stone, following these simple steps. …read all…
Posted on 17 May 2024 by ScegliAuto
Moto Guzzi V7 Stone
Change the Moto Guzzi V7 Stone engine oil and oil filter

Let's see together how to replace the Moto Guzzi V7 Stone engine oil and oil filter, performing the routine maintenance service. First of all we put our …read all…
Posted on 9 May 2024 by ScegliAuto
Moto Guzzi V7 Stone
How do you replace the Moto Guzzi V7 muffler?

In order to replace the muffler of the Moto Guzzi V7 Stone you have to loosen the screw that fixes the muffler support in its rear part. Once the support has …read all…
Posted on 20 April 2024 by ScegliAuto
Moto Guzzi V7 Stone
How to replace the brake and clutch lever on the Moto Guzzi V7 Stone

Today we will see, in this video tutorial, how to remove and replace the front brake and clutch lever of the Moto Guzzi V7 Stone. First we are going to remove …read all…
Posted on 16 April 2024 by ScegliAuto
Moto Guzzi V7 Stone
Replacing the battery on the Moto Guzzi V7 Stone

In this video we see the instructions that will allow us to remove and replace the battery on a 2014 Moto Guzzi V7 Stone dek. First of all, let's remove the …read all…
Posted on 12 February 2024 by ScegliAuto
Battery (1) (1) Muffler (1) Engine oil (1) Seat (1) (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos