Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Nissan
  4. :
  5. Altima
  6. : How to disassemble the gearbox in the Nissan Altima?

Nissan Altima - Video tutorial

Model: Nissan Altima L33 - Years 2013-2018
Part: Gearbox
Operation: How to disassemble the gearbox in the Nissan Altima?

In this tutorial we can see how to disassemble the CVT gearbox in the Nissan Altima, an operation that requires good manual skills and a lot of experience. First of all we lift the car on a bridge or with a jack, obviously taking the necessary safety measures, after which we remove both wheels and then the entire engine cover. We continue by removing the air filter box, the battery, the control unit and its support, then we move under the vehicle and disconnect the exhaust pipe. Finally, we disassemble the lower frame, extract both drive shafts and proceed with the disassembly of the gearbox, taking care to support it with a suitable support.


Posted on 6 December 2022 by ScegliAuto



Where is the fuse box located in the 2004 Nissan Altima?
Nissan Altima (2002-2006 / L31) If you have not been able to find the box that contains all the various fuses of your 2004 Nissan Altima, do not worry because we will give you all t
How to disassemble the rear bench of the Nissan Altima
Nissan Altima (2002-2006 / L31) Today's guide will show us the steps on how to disassemble the rear seat of the Nissan Altima, following the instructions below. First, we open the r
Where is the fuse box located in the Nissan Altima?
Nissan Altima (2013-2018 / L33) In this new mini guide, we will discover where the fuse box is located inside your Nissan Altima (year 2013-2018). Before proceeding, however, you mu

Other guides that may interest you

    Frequently Asked Questions

    • Altima 2013-2018 - What is the problem with the 2015 Nissan Altima overdrive (OD)? Read Answer
    • Altima 2013-2018 - How to fix gear sticking on 2013 Nissan Altima? Read Answer
    • Altima 2013-2018 - What are the problems with the Nissan Altima gearbox? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos