Do it yourself
| ||||
|
Vauxhall Astra - Video tutorial
Model: Vauxhall Astra
Astra J
- Years 2009-2016 If it happens that the particulate filter clogging warning light remains on on the instrument panel display, it means that the clogging level is so high that the normal regeneration process cannot free the filter and this could also compromise the operation of the engine at all. to the detriment of the turbine first of all; it is therefore necessary to go to the workshop where the filter will be treated with special detergents capable of unblocking it and allowing normal regeneration to be reactivated; therefore wait until the filter is cold, remove the temperature probe and spray the appropriate additives inside the filter, wait for them to act and then reassemble the probe, start the engine leaving it at idle until it has completely evaporated and take a turn with the car in order to reach the right temperature and allow the activation of regeneration.
Posted on 2 September 2023 by ScegliAuto
Replacing the diesel filter of an Opel Astra H
Vauxhall Astra (2004-2010 / Astra H) The video shows how to replace the diesel filter of an Opel Astra H. This operation takes a few minutes and a bit of manual dexterity. First, remove
How to clean the EGR valve of the Opel Astra
Vauxhall Astra (2009-2016 / Astra J) To carry out this operation, it will be necessary to unhook the hood and lift it to be able to identify the valve concerned, by unscrewing the bolts
How to disassemble and clean the throttle body of the Opel Astra
Vauxhall Astra (2004-2010 / Astra H) In this guide, let's see how to disassemble the throttle body, cleaning or replacing it, of the Opel Astra, by following these simple steps. First of Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.025
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |