Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Zafira
    4. : How to replace the stabilizer bar on the Opel Zafira version A.

Vauxhall Zafira - Video tutorial

Model: Vauxhall Zafira T98, Zafira A, MK 1 - Years 1999-2005
Part: Anti roll bar
Operation: How to replace the stabilizer bar on the Opel Zafira version A.

Let's see how to replace the front stabilizer bar on the Opel Zafira Version A: loosen the bolts of the front wheels and lift the vehicle. Place it on jack stands and then remove the front wheels. Using 19mm wrenches, unscrew the retaining bolt and remove the bar from its housing. Install the new one, attaching it to its support and screwing it back with the previously removed bolt. Tighten it properly, but without overdoing it. We can proceed in the same way on the other side. Now we can put the wheels back in place and lower the vehicle to the ground. Job done.


Posted on 11 September 2023 by ScegliAuto



How to replace starter motor on Opel Zafira
Vauxhall Zafira (2005-2011 / MK 2, Zafira B, A05) We replace the damaged starter motor on an Opel Zafira. Let's see the disassembly of the piece. We disconnect the electrical terminals of the battery
How to install a rear spoiler on the Opel Zafira B.
Vauxhall Zafira (2005-2011 / MK 2, Zafira B, A05) In this video, we see how to install a rear spoiler on the Opel Zafira version B. We can get the part on Amazon with the code B00U14CR42, priced at 9
How to replace the key battery on the Opel Zafira MK3
Vauxhall Zafira (2011-2019 / MK 3, Zafira C) In this short video we will see the steps that will allow us to remove and replace the key remote control battery on the Opel Zafira C, third series,

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos