Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Peugeot
    3. :
  3. Citystar 125
    4. : How do you reset the Peugeot Citystar 125 service warning light?

Model: Peugeot Citystar 125
Part: Checks and maintenance
How do you reset the Peugeot Citystar 125 service warning light?

In order to reset the Peugeot Citystar 125 Service warning light, you have to go to turn on the instrument panel to make sure that the warning light is actually on on the car's instrument panel. At this point it will be necessary to turn off the instrument panel and hold down the button located on the left of the latter, immediately below the speedometer. Then it will be possible to insert the ignition key inside the ignition switch and turn it: in this way the warning light will disappear from the instrument panel. It will be possible to verify that the reset has taken place by switching the panel off and on again.


Posted on 23 August 2022 by ScegliAuto



How to replace the rear light bulbs in the Peugeot Citystar 125 scooter?
Citystar 125 In this tutorial we can see how to replace the rear light bulbs on the Peugeot Citystar 125 scooter, a very simple and fast operation. First of all,
How do you replace the rear light bulb on a Peugeot Citystar 125?
Citystar 125 In order to replace the bulb in the rear light on the Peugeot Citystar 125, you need to loosen the two side screws which are located right on the rea
How to replace the fuel pump of the Peugeot Citystar 125?
Citystar 125 In order to replace the fuel pump of the Peugeot Citystar 125 you have to remove the protection panel located on the footrest of the motorcycle and a

How do you replace the headlight bulb of the Triumph Daytona 675R?

In order to replace the headlight bulb of the Triumph Daytona 675R, you need to loosen the screws that secure the appropriate protective panels inside the bulbs: these will be immediately below the handlebars, on the sides of the front fork. Once these covering panels have been removed, it will be possible to disconnect the connector connected to the bulb, removing it from its housing; at this point, it will be possible to connect the new bulb to the connector, inserting it into the headlight and verifying that everything works correctly.

Watch the video!


by ScegliAuto

More videos