Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Megane
    4. : How to replace the battery of the Renault Megane key remote control

Renault Megane - Video tutorial

Model: Renault Megane Megane 2 - Years 2002-2010
Part: Battery
Operation: How to replace the battery of the Renault Megane key remote control

These short and simple steps will show us how to disassemble and replace the battery of the Renault Megane key remote, following the instructions below. First, take the remote control in hand and start removing the physical key from the remote control; then remove the battery tray, as shown in the video. At this point, install the new battery, of the correct type and with the same code (in this case a CR 2025 3V); reassemble the battery correctly and insert the key into the remote control, finally checking the operation of the commands.


Posted on 16 May 2024 by ScegliAuto



How to change the remote control battery of a Renault Megane
Renault Megane (2008-2015 / Megane III, Megane 3) How to change the battery of the remote control key of a Renault Megane? Let's see how to do it in this detailed video. We take the remote control ca
How do you replace the battery of the Renault Megane remote control?
Renault Megane (2015-2023 / Megane 4, Megane IV) In order to replace the battery of the Renault Kadjar remote control, you need to use an object to pry and detach the clips that hold the two halves
How to replace the remote control battery of Renault Megane
Renault Megane (2015-2023 / Megane 4, Megane IV) In this video we will see how to replace the exhausted battery in the Renault Megane remote control; this video also applies to other contemporary mo

    Frequently Asked Questions

    • Megane 2008-2015 - Why doesn't the Renault Megane III start? Read Answer
    • Megane 2008-2015 - Where are the fuses located on a Renault Megane 3? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos