Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Roewe
  4. :
  5. Rx8
  6. : How do you replace the front grille of the Roewe RX8?

Roewe Rx8 - Video tutorial

Model: Roewe Rx8 MK 1 - Years 2018-2024
Part: Grille
Operation: How do you replace the front grille of the Roewe RX8?

In order to replace the front grille of the Roewe RX8, you need to open the hood so that you can loosen the screws that secure the grille from its upper part. After these screws have been loosened, it will be possible to access those located inside the front wheel arches and those located at the bottom of the bumper itself. Once all these screws have been unscrewed, it will be possible to detach the bumper and the corresponding grille, so that they can be replaced with new pieces; these will need to be installed with the appropriate corresponding screws.


Posted on 29 June 2023 by ScegliAuto



How to replace the coolant on Roewe Rx8?
Roewe Rx8 (2018-2024 / MK 1) It is possible to empty and replace the coolant in the car by following the instructions below: open the bonnet and lift the car at the front. The op
How to change the oil and filter on the Roewe Rx8?
Roewe Rx8 (2018-2024 / MK 1) To be able to replace the oils and filter on the car it is necessary to proceed as follows: open the bonnet and lift the car, locate the system drain
How to do-it-yourself change the Roewe Rx8 engine oil?
Roewe Rx8 (2018-2024 / MK 1) The whole procedure should take about 45 minutes and must be performed with the car parked on a perfectly level surface or, better yet, on jack stand

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos