Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Skoda
    3. :
  3. Enyaq Iv
    4. : How to replace the rear lights in the Skoda Enyaq Iv?

Skoda Enyaq Iv - Video tutorial

Model: Skoda Enyaq Iv MK 1 - Years 2020-2024
Part: Tail light
Operation: How to replace the rear lights in the Skoda Enyaq Iv?

In this tutorial we can see how to replace the rear lights in the Skoda Enyaq Iv, an extremely simple and quick operation. First of all, make sure the key is not inserted, then open the trunk door and remove the plastic cover along the inner edge of the headlight in question. Next, unscrew the two bolts that have just been released using a Torx T25 key, grab the headlight and separate it from the body by pulling it towards you. At this point, all that remains is to disconnect the power connector and install the replacement following the reverse procedure.


Posted on 20 April 2024 by ScegliAuto



What is the fuse layout of the Skoda Enyaq iV?
Skoda Enyaq Iv (2020-2024 / MK 1) In this video, we can see the fuse diagrams of the Skoda Enyaq iV and the location of their respective boxes, to consult in case we need to check the
What is the fuse layout of the Skoda Enyaq iV?
Skoda Enyaq Iv (2020-2024 / MK 1) If one of the devices in our Skoda Enyaq iV suddenly stops working, we can first check the status of the corresponding fuses whose diagrams are indic
What is the fuse layout of the Skoda Enyaq iV?
Skoda Enyaq Iv (2020-2024 / MK 1) In this video we can see where the fuse boxes of the Skoda Enyaq iV are located and what their respective diagrams are, to consult in case we need to

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos