Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Suzuki
    3. :
  3. Burgman 400
    4. : How to replace the rear turn signals on the Suzuki Burgman 400 scooter?

Model: Suzuki Burgman 400
Part: Rear light bulb
How to replace the rear turn signals on the Suzuki Burgman 400 scooter?

In this tutorial, we can see how to replace the rear turn signals on the Suzuki Burgman 400 scooter, a very simple and quick operation. First of all, make sure that the key is not inserted, then go to the back of the scooter, grab the panel below the taillight and unclip it. Next, locate the bulb in question, rotate it slightly counterclockwise and remove it from the housing. At this point, we can disconnect the connector, insert the replacement and reassemble everything. Repeat the operation on the opposite side, if necessary.


Posted on 4 May 2024 by ScegliAuto



How to reset the service on the Suzuki Burgman 400 scooter?
Burgman 400 Resetting the service on the Suzuki Burgman 400 scooter, as we can see in this tutorial, is an extremely simple and quick operation. Before proceedin
Where is the battery located in the Suzuki Burgman 400 scooter?
Burgman 400 In this video, we can see where the battery is located in the Suzuki Burgman 400 scooter, which is useful in case we need to replace it or perform an
Where is the battery located in the Suzuki Burgman 400 scooter?
Burgman 400 In this video, we can see where the battery is located in the Suzuki Burgman 400 scooter and how to proceed in case we need to replace it. As shown,

How to remove the stator of the Peugeot Speedfight 2

Today we will see, in this video tutorial, how to disassemble and replace the stator of the Peugeot Speedfight 2 scooter, following these simple steps. In this case, the disassembly operation is carried out with the engine removed from the bodywork; then, once the rotor has been removed, we can go and unscrew the fixing screws of the stator, in order to remove it from the engine casing together with the electrical wiring, as shown in the video. At this point we are going to replace the component with the new one, with the original spare part; we install the stator in the correct direction, finally adjusting the advance.

Watch the video!


by ScegliAuto

More videos