Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Corolla
    4. : How to replace the rear hatch closure of the Toyota Corolla.

Toyota Corolla - Video tutorial

Model: Toyota Corolla MK 3 - Years 2006-2013
Part: Locking the trunk
Operation: How to replace the rear hatch closure of the Toyota Corolla.

In this short and simple guide, we will see the steps that will allow us to disassemble and replace the trunk latch of the Toyota Corolla. First, we open the rear door and start removing its inner lining by removing the plastic clips. Then, we disconnect the electrical connector of the actuator and use a 10mm socket wrench to unscrew the two screws of the lock, so we can remove it, as shown in the video. At this point, we install the new trunk latch, applying the reverse procedure for reassembly!


Posted on 2 September 2023 by ScegliAuto



How do you replace the rear headlight bulb of the Toyota Corolla?
Toyota Corolla (2013-2019 / ) In order to replace the rear headlight bulb of the Toyota Corolla, you need to open the rear hatch: the headlight assembly will consist of a part on
How do you replace the license plate light bulb on a Toyota Corolla?
Toyota Corolla (2006-2013 / MK 3) The replacement of the license plate light bulb of the Toyota Corolla is done by lifting the rear hatch: in this way, it will be possible to use an o
How do you replace the rear headlight bulb of the Toyota Corolla Verso?
Toyota Corolla (2000-2007 / MK 2) To replace the rear headlight bulb of the Toyota Corolla Verso, you need to open the rear hatch of the car so you can access the components inside th

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos