Do it yourself
| ||||
|
(Various brands) Various - Video tutorial
Model: (Various brands) Various
In this video, we see how to change a half shaft: it is a component that transmits torque from the differential. The arrangement and number of half shafts depend on the type of traction: front, rear, or all-wheel drive. Changing a half shaft becomes necessary if a homokinetic joint is damaged. We need to loosen the fastening element that connects the half shaft to the wheel hub, but it may also be necessary to disconnect some suspension components. The homokinetic joint may need to be removed with light hammer blows. The internal homokinetic joint can be fixed in different ways: for example, it can be fastened with bolts to the differential flange, or it can be attached to the splined shaft that protrudes from the differential. The video considers all the various options in detail for removing the internal homokinetic joint and for its installation in the new one, with the repositioning of the half shaft on the opposite side, in the wheel hub. If the transmission fluid has been drained, pour in the new one (of course, the vehicle must be in a perfectly horizontal position). Once this is done, we can remount the wheel and lower the vehicle to the ground.
Posted on 20 October 2023 by ScegliAuto
How to change the gear knob on an Audi.
(Various brands) Various Let's see how to change the gear knob on an Audi car: let's see how to change only the knob without changing the gear boot, though, because usually t
How a drive shaft is made
(Various brands) Various In a motor vehicle, the drive shaft is basically a shaft that transmits motion from the differential, or gearbox, to the hub of each wheel. And if th
How to replace a drive shaft
(Various brands) Various To carry out this operation easily, it will obviously be necessary to remove the wheel in question in order to have enough space for the following op Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.059
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |