Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Golf
    4. : How to replace the front axle boot of the Volkswagen Golf 2.0 TDI.

Volkswagen Golf - Video tutorial

Model: Volkswagen Golf Golf VI, Golf 6, MK 6, 5K1 - Years 2008-2012
Part: Drive shaft
Operation: How to replace the front axle boot of the Volkswagen Golf 2.0 TDI.

Today we will see the instructions that will allow us to disassemble and replace the front axle boot of the Volkswagen Golf 2.0 TDI. First, we lift the vehicle and start by dismantling and removing the front wheel. Then, we disconnect the brake system from the front axle by unscrewing the central screw of the wheel bearing, as shown in the video. At this point, we remove the axle and then the boot, replacing it with the new one. We then reassemble the front axle and the entire brake system, following the reverse procedure of disassembly.


Posted on 23 August 2023 by ScegliAuto



Remove the front axle shaft on the Volkswagen Golf 4
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) In this video tutorial we will see how to remove and replace the front axle shaft on Volkswagen Golf MK4, fourth series, following the instructions b
Replacement of the front axle shaft of the Volkswagen Golf 6
Volkswagen Golf (2008-2012 / Golf VI, Golf 6, MK 6, 5K1) Let's see in this video tutorial how to disassemble and replace the front axle shaft of the Volkswagen Golf sixth series, following the instructions
How to replace the timing belt on the Volkswagen Golf 6 1.6 TDi?
Volkswagen Golf (2008-2012 / Golf VI, Golf 6, MK 6, 5K1) To be able to replace the timing belt of the Volkswagen Golf 6 1.6 TDi you have to open the hood, so that you can access the left side of the engine

    Frequently Asked Questions

    • Golf 2003-2008 - How much does a VW Golf drive shaft cost? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos