Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Volkswagen
  4. :
  5. Passat
  6. : Replacement of the cabin heating radiator of the Volkswagen Passat

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat 3C, B6 - Years 2005-2010
Part: Passenger compartment heating radiator
Operation: Replacement of the cabin heating radiator of the Volkswagen Passat

Following these short and simple instructions, we will see how to disassemble and replace the heater radiator of the Volkswagen Passat. First of all, lift the vehicle and start disconnecting the coolant hose found next to the pulley, letting the fluid drain into a container; then disconnect the tubing found on the back of the engine compartment, as shown in the video. At this point, remove the plastic cover found under the steering wheel and proceed with disassembling the radiator, unscrewing the screws and disconnecting the tubing.


Posted on 16 May 2024 by ScegliAuto



How do you replace the heating radiator of the Volkswagen Passat?
Volkswagen Passat (2010-2014 / B7) The procedure for replacing the cabin heating radiator in the Volkswagen Passat involves loosening the screws that secure the panel located on the ri
How do you replace the heating radiator of the Volkswagen Passat?
Volkswagen Passat (2010-2014 / B7) The replacement of the heating radiator of the Volkswagen Passat is done by loosening the screws that secure the side protection panel of the footwel
How to remove the passenger compartment heating radiator of a Volkswagen Passat
Volkswagen Passat (2010-2014 / B7) Before we can start, we will have to open the front hood of our Volkswagen Passat. So let's start by disengaging and removing the air filter sleeve.

Other guides that may interest you

    Frequently Asked Questions

    • Passat 2005-2010 - Where is the Volkswagen Passat heating radiator located? Read Answer
    • Passat 2005-2010 - Where is the interior heating radiator of the VW Passat b6? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos