Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volvo
    3. :
  3. V40
    4. : Replacement of the diesel fuel filter of the Volvo V40 1.6D.

Volvo V40 - Video tutorial

Model: Volvo V40 MK 2 - Years 2012-2019
Part: Diesel filter
Operation: Replacement of the diesel fuel filter of the Volvo V40 1.6D.

Below are the instructions necessary to disassemble and replace the diesel filter of the Volvo V40 1.6D, following these simple steps. First, we open the hood and locate the diesel filter; then we disconnect the various filter pipes, also disconnecting the electrical connector, as shown in the video. At this point, we unscrew the fixing screws to remove and replace the diesel filter with the new one, as well as with the original one; we connect it, checking the condition of all the diesel pipes, and finally start the engine!


Posted on 17 May 2024 by ScegliAuto



How do I replace the Volvo V40 diesel filter?
Volvo V40 (2012-2019 / MK 2) In order to replace the Volvo V40 diesel filter, you have to open the hood so that you can remove the plastic cover from the top of the engine block.
Where is the fuel filter located in the Volvo V40?
Volvo V40 (2012-2019 / MK 2) In this video we can see where the fuel filter is in the Volvo V40 D2 and how to remove it, useful in case we want to carry out maintenance without h
How do you empty the fuel tank of the Volvo V40?
Volvo V40 (1995-2012 / MK 1) To be able to empty the tank of the Volvo V40 you have to open the hood so that you can unhook the fuel return pipe. The end of this tube must theref

    Frequently Asked Questions

    • V40 2012-2019 - Where is the fuel filter located in the Volvo V40? Read Answer
    • V40 2012-2019 - What is the location of the fuel filter on the Volvo V40? Read Answer
    • V40 2012-2019 - How often do you change the diesel filter on Volvo V40? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos