Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Yamaha Mio - Videoguide

Yamaha Mio
How do you replace the rear wheel of the Yamaha Mio?
In order to replace the rear wheel of the Yamaha Mio, you need to loosen the screws that hold the exhaust on the right side of the bike, removing it from its …read all…
Posted on 11 February 2024 by ScegliAuto
Yamaha Mio
How to replace the battery of the Yamaha MIO I 125S scooter remote control?
In this tutorial we can see how to replace the battery of the Yamaha MIO I 125S scooter remote control, an extremely simple and fast operation. To do this, we …read all…
Posted on 29 May 2023 by ScegliAuto
Yamaha Mio
How to replace the battery of the Yamaha MIO I 125S scooter remote control?
In this tutorial we can see how to replace the battery of the Yamaha MIO I 125S scooter remote control, an extremely simple and fast operation. To do this, we …read all…
Posted on 18 May 2023 by ScegliAuto
Yamaha Mio
Replacing the battery on Yamaha Mio i125
After raising the saddle and completely emptying the compartment below, you can easily see the battery compartment located in the lower part of the same. Then, …read all…
Posted on 12 February 2024 by ScegliAuto
Yamaha Mio
Oil change on Yamaha Mio 125
For this scooter model it is recommended to use 10W-40 4-stroke synthetic oil. The oil drain bolt is obviously located at the bottom, and in this case on the …read all…
Posted on 12 January 2024 by ScegliAuto
Yamaha Mio
Oil change on Yamaha Mio
It is recommended for this model to use synthetic oil for 2t 15W-40 engines. Start the engine for a few minutes so that the circulating oil warms up and thus …read all…
Posted on 6 January 2024 by ScegliAuto
Battery (1) Key (2) Engine oil (2) Wheel (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos