Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Rear Window Seal on the BMW 5 Series

Model: BMW Serie 5 E61, E60 - Years 2003-2010

In this video tutorial, you will see the steps to remove and replace the rear window seal on the BMW 5 Series. First, move to the back of the vehicle and open the trunk; then use a thin plastic trim tool to start removing the seal from the sides, as shown in the video. At this point, clean the surface where the seal sits on the rear window thoroughly; then apply the new seal, inserting it perfectly by following the reverse procedure!

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

BMW Serie 5 (1995-2003 / E39) To replace the rear window seal, first remove the corner segments at each corner. Then, carefully lift and pull out the actual seal with all necessar…
BMW Serie 5 (2010-2017 / F11, F10) The fuse diagram for the BMW 5 Series F10 and F11 is detailed in the owner's manual. If this is lost, refer to the diagram shown in the attached vide…
BMW Serie 5 (2010-2017 / F11, F10) To locate the OBD port on your BMW 5 Series F10, follow the steps outlined in this guide. First, open the driver's door, then enter the vehicle and l…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos