Ön cam kaldırma motorunun değiştirilmesi

The damaging of the window regulator slide rails still requires the replacement of the entire system.
Using a small plastic lever, remove the rectangular-shaped cap in front of the inner handle grip and the ones located just below the armrest. Then unscrew the screws beneath the removed caps.
With the same plastic lever, detach the panel molding and unscrew the other two screws present.
At this point, release the snap fasteners along the edges of the panel and pull it upwards to remove it from the window scraper seal; then disconnect the opening cable and the connectors connected to the speakers and remove the panel.
Then unscrew the fixing screws of the side airbag: to release the airbag detonator connector, it is necessary to lift the safety latch first.
Then detach the sound-absorbing panel and remove it.
Lower the window until the pins of the glass fixing claws align with the appropriate access holes of the key inside the door.
Loosen the pins of the glass fixing claws and remove it.
Disconnect the connector connected to the window regulator motor and unscrew all the fixing pins of the window regulator system and remove it from the door.
Then disassemble the motor from the old window regulator system and apply it to the new one, which can then be installed in the door and fixed with the respective pins.
Connect the connector to the motor and position the glass fixing claws as done previously; then insert the glass into the guides and tighten the fixing pins of the claws; reconnect the connectors and reassemble what was previously removed.