Arka stabilizasyon çubuğunun sökülmesi ve değiştirilmesi.

If you want to achieve greater stability at the rear and better cornering grip, you could consider replacing the rear anti-roll bar. As seen in the video, the red anti-roll bar has a larger section than the original one. Before proceeding with the actual installation, you need to lubricate the rubber mounts.

Then, screw on the two collars, but do not tighten them as they will be positioned later.

Now, you can start removing the original anti-roll bar by positioning yourself under the car, which you will have raised with a jack in the meantime. Begin by unscrewing the two anchoring points of the bar. At this point, unscrew the screws of the two mounts.

Once the original one is removed, you can install the new one, immediately fixing it to the anchoring points, but without tightening the screws completely. Now, attach the two mounts, making sure that the bar is perfectly centered by checking that the spaces between the mount and the bar are equal.

Proceed by tightening the screws of the mounts (for those who have it, you can do it with a torque wrench set to 67, 80Nm) and then the screws of the anchor points. Finally, position the two collars near the mounts, leaving a space the thickness of a sheet of paper.