Kumanda anahtarının sökülmesi ve tamiri

Ayrıntılı talimatlar - The malfunctioning anomaly of the remote control key is often due to a solder joint on the electronic board of the remote control itself, which must therefore simply be restored.
Furthermore, since the key must be completely disassembled, this is an opportunity to replace the remote control covers, easily available in the aftermarket (generally, the key or "blade" that will need to be subsequently encrypted is also provided).
The first operation to be done is to remove the battery compartment cap and extract the two batteries present (check their voltage with a tester and replace them if necessary). Then, separate the two halves of the remote control, paying attention to the plastic pin and the spring present.
Then, remove the electronic circuit, check the integrity of the microswitch, and re-solder the fixing solder joint of the battery support bracket (part that protrudes from the circuit).
At this point, insert the batteries and test the functionality of the remote control before reassembling it.
Then, reposition the electronic circuit in its respective shell, place the plastic pin in the key (there is only one mounting position that allows the tooth on the pin to align with the groove on the key), then insert the spring into the pin so that it hooks onto the bottom, and finally, attach the other end to the cover and snap the two covers together.
Check the functionality of the key's spring, insert the batteries and the corresponding cap, and test the functionality of the remote control.