Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A6
    4. : Where is the throttle body of the Audi A6 located and how to remove it?

Audi A6 - Video tutorial

Model: Audi A6 C6, MK 3 - Years 2004-2012
Part: Throttle body
Operation: Where is the throttle body of the Audi A6 located and how to remove it?

In this video, we can see where the throttle body of the Audi A6 is located and how to proceed in case we need to disassemble it. As shown, it is located in the left area of the engine compartment, just behind the headlight, positioned about halfway through the intake manifold. To disassemble it, we first remove the engine cover, then temporarily extract the oil control rod to access the lower bolt. Once this is removed, we continue with the second bolt and loosen the screw from the opposite metal clamp. At this point, we can disconnect the connector and proceed with the installation of the replacement if necessary.


Posted on 9 July 2023 by ScegliAuto



Replacement of the throttle body for the Audi A6 3.2 V6.
Audi A6 (2004-2012 / C6, MK 3) The main instructions for today will show us how to disassemble and replace the throttle body of the Audi A6 3.2 V6, in simple steps. First, we open
Throttle body replacement instructions
Audi A6 (2004-2012 / C6, MK 3) start by removing the plastic cover located above the engine and intercept the throttle body located immediately behind the alternator, connected to
Cleaning the EGR valve and intake manifold
Audi A6 (2004-2012 / C6, MK 3) If you experience problems with the performance of the engine, excessive smoke and sometimes even difficulty in the starting phase, then it is likely

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos