Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Audi
  4. :
  5. A6
  6. : Replacement of the throttle body for the Audi A6 3.2 V6.

Audi A6 - Video tutorial

Model: Audi A6 C6, MK 3 - Years 2004-2012
Part: Throttle body
Operation: Replacement of the throttle body for the Audi A6 3.2 V6.

The main instructions for today will show us how to disassemble and replace the throttle body of the Audi A6 3.2 V6, in simple steps. First, we open the engine hood of the car and begin to remove the plastic engine cover and the intake hose; then we unscrew the fastening screws of the throttle body, disconnecting the electrical connector of the position sensor to remove it, as shown in the video. At this point, we clean the throttle body or directly replace it, applying the reverse procedure for reassembly!


Posted on 24 January 2024 by ScegliAuto



Throttle body replacement instructions
Audi A6 (2004-2012 / C6, MK 3) start by removing the plastic cover located above the engine and intercept the throttle body located immediately behind the alternator, connected to
Where is the throttle body of the Audi A6 located and how to remove it?
Audi A6 (2004-2012 / C6, MK 3) In this video, we can see where the throttle body of the Audi A6 is located and how to proceed in case we need to disassemble it. As shown, it is loc
Rear light replacement on Audi A6
Audi A6 (1997-2004 / MK 2, C5) Replacement of the rear light of an Audi A6? Let's see how it is removed from inside the car body. We open the trunk lid, remove the cloth cover on t

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos